I have a natural gas oil furnace installed into my home. It relies on a duct method to carry heated plus cooled air between the oil furnace plus the rooms of the house. The conditioned air passes through the ducts, picking up dust, bacteria plus other contaminants, plus then is introduced via vents cut into the ceilings. These pollutants are circulated throughout the condo plus breathed in by my family. Because the heat is introduced from overhead vents, the warmest temperature is consistently up near the ceiling, where it does no nice at all. Down by the floor, the air is often rather chilly, forcing me to raise the control component setting. The oil furnace then blasts a tremendous amount of overheated air, continuing to work until the control component setting is achieved. It then shuts completely off, creating genuinely unpleasant temperature variations. This process is loud, aggravating plus pricey, the oil furnace requires frequent service. I need to update the air filter every month plus hire a professional HVAC specialist to service the component every fall. I also need to worry about the condition plus upkeep of the duct system. If there is a problem with the oil furnace, I am consistently distraught about potential carbon monoxide poisoning. I wish I could afford to tear the duct method plus oil furnace completely out plus update them with a hydronic gas furnace. I’d savor to install a boiler in the basement plus radiant heating under the floors in every room. Radiant heated flooring is completely noiseless, requires little service, plus the heat originates at floor level. It rises genuinely slowly plus evenly, with the warmest temperatures remaining closer to the ground plus allowing lower control component settings. There are no drafts or chilly spots, plus radiant heating doesn’t introduce contaminants into the breathing air.